Multiple instances of RStudio Package Manager can share the same data in highly available (HA) and load-balanced configurations. In this document, we refer to these configurations as “HA” for brevity.
Follow the checklist below to configure multiple RStudio Package Manager instances for HA:
- Ensure that all node clocks are synchronized Section 12.2 of the admin guide
- Install and Configure the same version of RStudio Package Manager on each node - Section 2 of the admin guide
- HA requires using a PostgreSQL database. All nodes in the cluster must use the same PostgreSQL database.
- Configure each server’s
Server.DataDir(Section 7.6 of the admin guide) to point to the same shared location. Be sure to read Section 12.3.3 of the admin guide for additional information on the recommended settings for the shared directory.
HA Time Synchronization Requirements
The clocks on all nodes in an HA configuration must be synchronized. We recommend configuring NTP for clock synchronization.
RStudio Package Manager nodes in an HA configuration are not self-aware of HA. The load-balancing responsibility is fully assumed by your load balancer, and the load balancer is responsible for directing requests to specific nodes and checking whether nodes are available to accept request
RStudio Package Manager only supports HA when using a PostgreSQL database.
Shared Data Directory Requirements
RStudio Package Manager manages repository content within the server’s data directory. This data directory must be a shared location, and each node’s
Server.DataDir must point to the same shared location. See Section 7.6 of the admin guide for more information on the server’s data directory. We recommend and support NFS version 3 or 4 for file sharing.
RStudio Package Manager relies on being able to efficiently detect new files inside of the NFS-shared
DataDir. By default, NFS clients are configured to cache responses for up to 60 seconds, which means that it can take up to a minute before an RStudio Package Manager service is able to respond to certain requests. For most deployments, this is an unacceptably long delay.
Therefore, we strongly recommend that you modify your NFS client settings for the mount on which you’ll be hosting your
DataDir. Typically, the best way to accomplish this is to set
lookupcache=posfor your NFS mount, which will allow existing files to be cached but will contact the NFS server directly to check for the existence of new files. If this setting is not acceptable for your mount, you could alternatively consider shortening
actimeo so that your client becomes aware of new files within, say, 5 seconds, instead of the default of 60.
Updating HA Nodes
When applying updates to the RStudio Package Manager nodes in your HA configuration, you should follow these steps to avoid errors due to an inconsistent database schema:
- Stop all RStudio Package Manager nodes in your cluster.
- Upgrade one RStudio Package Manager node. The first update will upgrade the database schema (if necessary) and start RStudio Package Manager on that instance - Section 5.2 of the admin guide.
- Upgrade the remaining nodes.
If you forget to stop any RStudio Package Manager nodes while upgrading another node, these nodes will be using a binary that expects an earlier schema version, and will be subject to unexpected and potentially serious errors. These nodes will detect an out-of-date database schema within 30 seconds and shut down automatically.
If you wish to move from an HA environment to a single-node environment, please follow these steps:
- Stop all RStudio Package Manager services on all nodes
- Reconfigure your network to route traffic directly to one of the nodes, unless you wish to continue using a load balancer.
- If you wish to move all shared file data to the node, then
- Configure the server’s
Server.DataDirto point to a location on the node, and copy all the data from the NFS share to this location - Section 7.6 of the admin guide
- Configure the server’s
- If you wish to move the databases to this node, install PostgreSQL on the node and copy the data. Moving the PostgreSQL databases from one server to another is beyond the scope of this guide. Please note that we do not support migrating from PostgreSQL to SQLite.
- Start the RStudio Package Manager process Section 5.1 of the admin guide