Nothing happens when clicking in the gutter
Breakpoints cannot be set anywhere; the most likely cause of this problem is that you're trying to set a breakpoint on a line that doesn't support breakpoints. Lines on which you can set breakpoints are those which:
- are in R code (.R file);
- contain an R statement (i.e. are not just comments or whitespace); and
- are a top-level expression or a simple, named function
A warning bar appears when setting a breakpoint
You may occasionally see an error bar when setting a breakpoint, indicating that the breakpoint hasn't been set.
The circle outline indicates that RStudio will remember the breakpoint, but the breakpoint has not yet been enabled. You need to take further action to enable it.
If this happens, the following should enable the breakpoint.
- Save the file
- Source the file (by pressing the Source button in the toolbar). If developing a package, rebuild and reload the package.
If the code on which you're setting a breakpoint is executing but the breakpoint is not being hit, it's possible that the type of code does not yet support breakpoints. Here are two common cases:
Complex function assignments
RStudio understands function assignments of the form:
name <- function(args, ...)
It does not understand more complex syntax.
In this case, the editor indicates that the current function is (Top Level) even when the cursor is inside
foo. Because the editor does not know which function to place the breakpoint in, the breakpoint on line 15 in this example won't work.
Code inside anonymous expressions is also immune to breakpoints, and for the same reason—the expression is neither a named function nor a top-level statement that can be stepped through as the file is sourced.
If you need a breakpoint in these cases, add the statement
browser() to create one manually.
Other notes and things to try
- RStudio's breakpoint functionality is built on R's
traceinfrastructure. It is possible to disable breakpoints in a function by calling
untraceon the function, and also possible to disable all breakpoints by disabling tracing. This is not recommended since the IDE does not check for these manipulations. Make sure
TRUEif you'd like RStudio breakpoints to work.
- In order to hit breakpoints during sourcing, you need to use the special debug sourcing command
debugSourceincluded in RStudio. If you are calling
sourcemanually on your file, breakpoints will still work, but will not be enabled until after all the code in the file has been executed.